/
0 - Getting Started (0.8.4 Kit)

0 - Getting Started (0.8.4 Kit)

  • Complete Draft

    • Picture of what is finished at end of section will be here

    Difficulty Very Easy

    Steps 5

    Estimated Time 5 minutes

    This section is a guide for reading the instructions. Please read it fully to avoid problems later.

    Step 1: Instruction Guide

    Colored boxes will match the instruction to the image

    20240124_165659-20240125-152227.jpg
    Example

     

    ATTENTION: If there is important info put it in warning panel

    General step instructions with black square.

    Colored squares are used matching with colored markers in images to highlight steps

    • Bulleted instructions under colored square are detailed instruction related to the above step.

    Tip: Extra info for steps will be in these panels.

    Step 2: Tools Needed

    20240125_090452-20240125-152114.jpg
    Example

     

    This step of each section shows what tools are needed for that section.

    2mm Allen key

    2.5mm Allen key

    3mm Allen key

    5mm Allen key

    TR10 Torx screwdriver

     

    For this assembly guide wire crimping and soldering is required.

     

    Step 3: Image viewing

    20240124_164336-20240125-152148.jpg
    Click on picture to enlarge it

     

    When viewing this guide online, you can click on the images to zoom in and view in full clarity.

     

    Step 4: Printed Parts Versioning

    20240124_160357-20240125-151847.jpg
    Example

    Most printed parts are labelled with two letters and a number. The letters can be used to help identify which part it is and the number indicates the version.

    Step 5: Tips for successful assembly

     

    Please follow these instructions throughout the assembly

    • Always read the instructions before starting each step. Some steps will have important warnings or specific directions that could cause problems if not followed.

    • Don’t just follow the pictures, the written instructions provide necessary information.

    Furthermore for not following just the pictures, sometimes the parts used in the pictures won’t match what you have or there may be parts shown that you haven’t gotten to yet.

    This is due to the parts we use changing over time and some of the pictures being taken out of order.

    • Use a reasonable amount of force. If parts are expected to need force to go together the step will make note of that. Otherwise, if you feel force is needed recheck the step to see if you have the correct parts and approach.

    • Ask questions: If you’re confused, leave a comment on the step and don’t be afraid to ask for help. It’s better to sort out confusion quickly rather than moving forward and having to undo your progress to correct mistakes.